TC35i AT Command Set
3.5 ATS18
s
m
obil
e
TC35i_ATC_V02.07 Page 83 of 439 1/30/04
Confidential / Released
Note
• The command applies only to circuit switched data and fax calls. For voice calls extended call release reports
can be retrieved using the command
AT+CEER.
Examples
EXAMPLE 1
EXAMPLE 2
ATS18=1
Enables the presentation of extended call release reports.
OK
ATD03012345678
Now, a mobile originated data call fails.
+CAUSE: 8:17
An extended error report is output, followed by the result code BUSY.
BUSY
The Location ID 8 stated in section 3.4.1 points to section 3.4.6, where
17 = "User busy".
ATS18=1
Enables the presentation of extended call release reports.
OK
ATD03012345678
Now, a mobile originated data call is set up.
CONNECT 9600/RLP
Hello,....
+++
Call ends after remote party hung up.
+CAUSE: 8:16
Normal call release is reported, followed by the result code NO CAR-
RIER.
NO CARRIER
The Location ID 8 stated in section 3.4.1 points to section 3.4.6, where
16 = "Normal call clearing".
To Next Page
Loading...
