page 62 579-1150 Rev M
4010ES IDNAC Fire Alarm System Installation Guide
8.2 Ethernet service port
The Ethernet service port J7 on the CPU card is used to connect the panel to a local PC. See below for the port location.
Figure 53: Ethernet service port
The Ethernet service port connects to the front panel Ethernet connection through a standard straight (non-crossover) Ethernet patch
cable. The front panel Ethernet connection is located on the top left of the 4010ES front panel. The service technician should connect his
PC to the CPU card through this front panel connection with a standard straight Ethernet cable. If this connection is not available, you may
plug the CPU Card connector J7 directly to the PC with a standard straight Ethernet cable.
Note:
If a BNIC card or an ES Net NIC card is used with the system, the CPU card Ethernet connection connects to it. The BNIC card or an ES Net
NIC card then connects to the Front Panel Ethernet Connection board.
Figure 54: Front Panel Ethernet Service Port
To Next Page
Loading...
Need help?
General
