Operation
20221560E 23
Sailboat
When sailing in WIND mode, the parameters are automatically
changed by the direction of the wind as per below or by the boat
speed.
The transition between HI and LO parameters and vice versa
will have a different characteristics with regards to the wind
angle compared with the transition controlled by the speed of the
boat.
If you loose too much speed e.g. when tacking, the parameters
will change to HI to gain sufficient rudder response. This should
be observed when setting the transition speed on sailboats.
2.9 Manual Selection of HI/LO Parameters
Manual selection of HI/LO parameters is necessary if there is no
speed input to the autopilot or if you want to override the
automatic control.
To toggle between LO and HI parameters, press the "AUTO"
button two times quickly.
A
AUTO
Quick
double
press
Notes !
1. If you are in NAV or WIND modes you need not
enter AUTO
mode to manually change the parameter set. Just make a
quick double press on the AUTO button.
To Next Page
Loading...
Need help?
General
