Simrad AP25 Instruction Manual

Simrad AP25 Autopilot
10 20222139A
TI25 Thruster Interface
The TI25 Thruster Interface is designed to provide a control
signal for operating a thruster interfaced to an AP25 system. It
operates on/off solenoids, or a Danfoss PVEM valve. The
Danfoss valve is a proportional valve that will provide full
thruster performance with the output from TI25. The thruster
output signal is calculated in the TI25 based on the mode of
operation and the heading information. Set-up is from the control
unit communicated via Robnet2. All settings are stored in the
thruster interface unit.
Refer to the TI25 manual.
Note ! TI25 must have software version 1.1.01 onwards.
Multiple stations
Multiple control units can be added to the system.
1.8 Software record
When the system is switched on, a status display shows the
software versions for the control unit and the autopilot computer.
See page 12.
Software version
Description
SW 1.2.00 First Volvo IPS compatible software for
AP25

Simrad AP25 Specifications

General

Brand	Simrad
Model	AP25
Category	Autopilot System
Language	English