Configuration and Setup
20222139A 77
Set Thrust Direction
(Only applicable if a thruster is connected)
Rotate the course knob
clockwise to activate the Set
thrust direction setting.
Rotate the course knob CW and verify that the vessel turns to
starboard. The thruster stops after 10 seconds, or when the
STBD button is pressed.
If the boat turns to port when the course knob is turned CW,
rotate the knob to port to ensure a starboard turn.
The autopilot has now been set to the correct thrust direction.
On thrusters, a change in direction command will always be
delayed 1 second to prevent thruster breakage.
Proceed to the “Parameters” item by pressing the STBD button
or return to STANDBY mode by pressing the STBY button.
Wind Offset
Note ! This offset only applies if you have a wind transducer directly
connected to SimNet (IS12TW) or a wind transducer that outputs
data on NMEA2000 format.
The Wind Offset feature
allows you to correct for a
fixed wind angle offset. Steer
the boat directly into the wind
with a damping of 15s. Keep
the bow a steady heading for
15-20 sec. and read the wind
angle. If necessary turn the
course knob to input an off set
that makes the display read
Wind 000°.
The Offset value can be either positive or negative.
To Next Page
Loading...
Need help?
General
