Simrad AP26 User Manual

Simrad AP26 and AP27 Autopilots
90 20222147A
Instance number
An item to identify units by a
number when the autopilot is
connected to a NMEA2000
Network. On SimNet units the
Instance number is added to the
product name e.g. AP26-1,
AP26-2 for easy identification
on various display screens.
SimNet gateway
Indicates which control unit that
transmits and receives
information on SimNet. The
display verifies by reading
‘Yes’, all other units read ‘No’.
Global SimNet reset
Resets the entire SimNet setup in
the Simrad Group and initiates a
new automatic interface setup.
See chapter 4.1.
Master Reset
Note ! A Master Reset is part of the final test at the factory, which will
reset the memories to factory settings. Unless you need to clear
all stored values during the installation setup procedure, you
should not perform a Master Reset.
Under Service in the
Installation Menu, select
Master reset of memories by
pressing the STBD button and
confirm this by rotating the
course knob clockwise.
The Master Reset needs a
double confirmation to
prevent an accidental reset. To
perform a Master Reset, rotate
the course knob clockwise
and observe the display; then
rotate the course knob counter

Simrad AP26 Specifications

General

Brand	Simrad
Model	AP26
Category	Autopilot System
Language	English