Simrad AP26 User Manual

Operation
20222147A 17
Alarms are presented in plain text to alert you of system and
external data failure conditions. Alarms include both audible and
visual presentations. The alarm listing is on page 97.
2.2 ON/OFF - Standby mode
Note ! At first time turn on see paragraph 4.1.
A single press on the STBY button switches the system ON and
the following status displays are shown:
Autopilot computer model
P00 M00 S000
AC05
Simrad
Self check
Power board revision
Main board revision
Autopilot model
HW rev. 00
SW 1.2.00
AP26
Simrad
Hardware revision
SW 1.1.00
Software version
Software release
Software release
Software version
Sn xxxxxx
SimNet no.
SW and HW revisions shown are examples only.
After approximately 5 seconds,
the following message is
displayed.
The system is now operative and the unit that was turned on
will show the Standby mode display. Other units in a
multistation system will display "Inactive". Control is
transferred to any single unit by pressing its’ STBY button.
The main Standby mode display
shows.
−
Standby mode
− Current heading 345°M
− Compass source: Rate
compass
− Rudder angle =00°.

Simrad AP26 Specifications

General

Brand	Simrad
Model	AP26
Category	Autopilot System
Language	English