Maintenance
Preventive maintenance
The GO7 does not contain any field serviceable components,
therefore the operator is required to perform only a very limited
amount of preventative maintenance.
Cleaning the display unit
A proper cleaning cloth should be used to clean the screen, where
possible. Use plenty of water to dissolve and take away salt remains.
Crystalized salt may scratch the coating if using a damp cloth. Apply
minimal pressure to the screen.
Where marks on the screen cannot be removed by the cloth alone,
use a 50/50 mixture of warm water and isopropyl alcohol to clean
the screen. Avoid any contact with solvents (acetone, mineral
turpentine, etc.), or ammonia based cleaning products, as they may
damage the anti-glare layer or plastic bezel.
To prevent UV damage to the plastic bezel, it is recommended that
the sun cover be fitted when the unit is not in use for an extended
period.
Cleaning the media port door
Clean the media port door regularly to avoid salt crystallization on
the surface, causing water to leak into the card slot.
Checking the connectors
The connectors should be checked by visual inspection only.
Push the connector plugs into the connector. If the connector plugs
are equipped with a lock, ensure that it is in the correct position.
Software upgrades
The latest software for the GO7 is available for download from our
website, simrad-yachting.com.
Detailed instructions for how to install the software are included in
the upgrade files.
17
110
Maintenance | GO7 Operator Manual
To Next Page
Loading...
Need help?
General
