A separate manual is provided with your CZone system. Refer to this
documentation and to the GO7 Installation manual for how to
install and configure the CZone system.
CZone dashboard
When the CZone is installed and configured, an additional CZone
dashboard is added to the Instruments panels.
You switch between a panel’s dashboards by selecting the left and
right arrow symbols or by selecting the dashboard from the menu.
Editing a CZone dashboard
You can customize a CZone dashboard by changing the data for
each of the gauges. Available editing options depend on the type of
gauge and which data sources that are connected to your system.
For more information, refer to "Instrument panels" on page 95.
GoFree wireless
The GO7 includes built-in wireless functionality that lets you use a
wireless device to remotely view (phone and tablet) and control the
system (tablet only). The system is controlled from the wireless
device by Apps downloaded from their relevant Application store.
Configuration and setup are described in the GO7 Installation
manual.
Ú
Note: For safety reasons, Autopilot and CZone functions
cannot be controlled from a wireless device.
Operating the system with a wireless device
When remote control is accepted, the active page is mirrored to the
wireless device.
The image on the wireless device includes softkeys used for
operating the GO7 system.
Remote controllers
You can connect an OP40 to the network and remotely control the
GO7.
A separate manual is included with the remote controller.
Introduction | GO7 Operator Manual
17
To Next Page
Loading...
