Automatic steering, keeping the vessel on a straight bearing
line by compensating for drift.
• Dodging
Returns to NoDrift mode after a heading change.
• NAV
Navigation steering. Steers the vessel to a specific waypoint or
through a route.
• WIND
Only available if the boat type is set to Sail in the Autopilot
Commissioning dialog. Automatic steering where the vessel
heading is changed to maintain a set wind angle.
• Tacking/Gybing
Only available if the boat type is set to Sail in the Autopilot
Commissioning dialog. Tacking/Gybing with apparent or
true wing angle as reference.
• WIND Nav
Automatic steering, using both wind and GPS data to steer the
vessel to a specific waypoint or through a route.
Standby mode
Standby (STBY) mode is used when you steer the boat at the helm.
Non-Follow Up (NFU, Power steering)
In NFU mode you use the port and starboard arrow buttons in the
autopilot pop-up to control the rudder. The rudder will move as
long as the button is pressed.
• Activate NFU mode by selecting the port or starboard arrow
button in the pop-up when the autopilot is in STBY or FU mode.
You return to STBY mode by selecting the STBY mode button in the
autopilot pop-up.
Follow-up steering (FU)
Ú
Note: FU mode is only available if you have an OP40 or
similar included in the system. The GO7 does not have a
rotary knob.
In FU mode you use the rotary knob to control the rudder angle.
Press the rotary knob, then turn the knob to set the rudder angle.
The rudder moves to the commanded angle and then stop.
• You select FU mode from the autopilot pop-up
Autopilot | GO7 Operator Manual
61
To Next Page
Loading...
Need help?
General
