Simrad NSE12 - Target Alarm Settings

Wiring the NSE | 39
Connecting HD Radar
+
_
B O
p
tional 2nd HD Radar
C
D
E
II
F
HH
G
G
J
KK
K
M
L
A
Brown RX-
White RX+
AT10HD
NMEA083 to SimNet
Converter Heading Only
Cut off 12 Pin
plug to expose bare wires
NMEA0183 10 Hz Heading
(e.g Gyro, Sat Compass)
Alternative: NMEA0183 heading
TX-
TX+
POWER
NETWORK
NETWORK NETWORK NETWORK NETWORK
2 kW 12 V DC ONLY
4 kW & 6 kW 12 or 24 V DC
10 kW & 25 kW 24 V DC ONLY
Ethernet
Scanner
AT10HD
Key Description
ANSE display
B HD Radar Scanner: Options are 2 kW or 4 kW Radome, and 6 kW, 10 kW or 25
kW open array.
C Scanner cable
D HD Radar Processor
E Network Expansion Port (NEP)
F Ethernet Adapter X over. RJ45 to Yellow 5 pin
G Ethernet network cable 5 pin yellow Male / Male
H Ethernet Adapter Straight through. RJ45 to Yellow 5 pin
I SimNet backbone.
J Power cable. Make sure a fuse is used. See Radar installation manual for fuse
size. Note voltage requirements are model dependant
K AT10HD: SimNet to NMEA0183 converter (Heading only @10 Hz). Provides
heading to the radar processor for MARPA calculations
L RC42 SimNet heading sensor. Required for radar chart overlay and MARPA)
M Optional 2nd Radar