Simrad NSE12 Installation Manual

56 | Commission the system
OP40 Controller Setup
From the factory the OP40 controller is not assigned to control any NSE unit and will not
be responsive until it has been assigned to control an NSE unit on the network.
NSE displays will need to be turned on using their PWR button (if not already switched on
by the yellow power control wire). When in OP40 configuration mode, all four OP40 LEDs
will be lit red. Once connected and powered up the OP40 configuration wizard can be
entered into at any time with a 5 second press of the DISPLAY key.
Assigning an OP40 control of a single display
Press 1, 2, 3 or 4 to assign DISPLAY
A to LED position 1, 2, 3 or 4 re-
spectively.
Example user presses 1
DISPLAY A is now assigned to LED posi-
tion 1 of this OP40
STBY
AUTO
PWR
1
3
6
7
PQRS
8
TUV
9
WXYZ
MNO
5
JKL
2
ABC DEF
GHI
4
0
STBY
AUTO
Assigning an OP40 to control multiple displays
Press DISPLAY key until the display to
be assigned shows the active display
page.
Displays connected to other NSE units
will show the inactive selection page
It is logical to assign LED(s) 1 through 4 (left to right) to units moving from left to right.
Note: During assignment the letters assigned to each display (for assignment purposes
only) are random and are not in any particular order.
Assign each display to an LED number by selecting a number one through four.
Unassign a display from an OP40
MENU
9
WIN

Simrad NSE12 Specifications

General

Brand	Simrad
Model	NSE12
Category	Monitor
Language	English