1
- 11 -
951-180-083-EN
Version 01
EN
1. Safety instructions
Annex I Part 2-5 of the CLP Regulation
(EC 1272/2008) that are marked with
hazard pictograms
GHS01-GHS 09
○ Use to feed / forward / store gases, lique-
fied gases, dissolved gases, vapors, or
fluids whose vapor pressure exceeds nor-
mal atmospheric pressure (1013 mbar)
by more than 0.5 bar at their maximum
permissible operating temperature
○ Use in an explosion protection zone
○ Use to feed, forward, or store lubricants
with solvents
○ Use in potentially explosive gases and
vapors whose ignition temperature is
less than 125% of the maximum surface
temperature
○ Use in potentially explosive dusts whose
minimum ignition temperature and glow
temperature are less than 150% of the
maximum surface temperature
○ Use in another, more critical explosion
protection zone
○ Use with a damaged, missing, or improp-
erly performed subsequent ATEX finish
1.5 Painting plastic components
The painting of all plastic components and
seals of the products described here is
prohibited.
Completely remove or mask affected com-
ponents before painting the main machine.
1.6 Modications to the product
Unauthorized modifications and changes
can have an unpredictable effect on safety.
Unauthorized modifications and changes
are therefore prohibited.
1.7 Prohibition of certain activities
The following activities must be performed
only by employees of the manufacturer or
authorized persons due to possibly unde-
tectable sources of error or due to statutory
requirements:
○ Replacement, modifications to the pis-
tons of the metering device elements
To Next Page
Loading...
Need help?
General
