- 16 -
951-180-083-EN
Version 01
EN
1. Safety instructions
○ Observe any possible wearing spots. Pro-
tect components appropriately.
○ All components used must be designed
for:
- The maximum operating pressure
- The maximum/minimum ambient tem-
perature
- The lubricant to be delivered
- The required ATEX zone
- The operating and ambient conditions
at the place of use.
○ No parts may be subjected to torsion,
shear, or bending.
○ Check parts for contamination before use
and clean if necessary.
○ Lubrication lines should be filled with
lubricant prior to assembly. This simplifies
subsequent venting of the system.
○ Adhere to the specified torques. Use
a calibrated torque wrench when
tightening.
○ Use suitable hoisting equipment when
working with heavy parts.
○ Avoid mixing up/incorrectly assembling
disassembled parts. Label parts.
1.19 First start-up, daily start-up
Ensure that:
○ All safety mechanisms are fully present
and functional.
○ All connections are properly connected.
○ All parts are correctly installed.
○ All warning labels on the product are fully
present, visible, and undamaged.
○ Illegible or missing warning labels are im-
mediately replaced.
To Next Page
Loading...
Need help?
General
