Carbur etor Engine Starting Procedure
Procedure
• R echec k throttl e c ontrol lever op eration .
• Ensure that the tether cord cap is in position and that the cord is
attached to your clothing eyelet.
• Ensure that the engine cutout switch is in the ON position.
• On fan-cooled models, turn ignition key to ON position.
• Activate the choke according to the temperature as explained be-
low.
Choke Application
Initial Cold St ar t ing Whe n Temperat ure is Below - 10°C ( + 15°F)
N O TE:
Do n ot op era te the throttle lev er w ith the ch ok e leve r on.
Set the choke lever to position 3.
N O TE: After the engine is started, let engine warm up at fast idle
until engine speed drops. Then, close off choke to ensure proper
air-fu el mixture .
1
2
3
A06H1KA
1. OFF
2. Position 2
3. Position 3
Initial Cold Starting When Tempera t ur e is A bove
- 1 0°C (above + 15°F)
Set the choke lever to position 2.
N O TE: After the engine is started, close off choke to ensur e proper
air-fu el mixture .
138
_________________________
To Next Page
Loading...
Need help?
General
