Attach tether cord to operator's clothing eyelet.
Start engine and allow it to warm up two or three minutes at idle
speed.
Release parking brake.
WARNING
Make sur e wid e-base snowm ob ile m echanical s tand is stab le.
Stay clear of the front of vehicle and the track. Do not use too
muc h throt tle during warm - up or whe n track is fre e-hanging.
Apply throttle until drive pull ey engages. Let track rotate at low
speed for several turns. The lower the vehicle temperature is the
lo nger vehicle w ar m-up should be.
Shut-off the engine and remove the w ide -base snowmobile mechan-
ical stand .
Skis m ay be frozen on the ground. Grab both skis one at a tim e by
their loops and lift their front end slightly off the ground.
After restarting engine, the vehicle can be driven at low speed for
the first 2 or 3 minutes of riding. After that, it may be driven up to
the le gal speed limit as per normal safety practices.
S hutting Off the Engine
Release throttle lever and wait until engine has returned to idle
speed.
Shut off the engine usi ng either ignition switch, engine cut-out
switch or teth er cut-out s witc h.
WARNING
Always rem ove tether cord cap and key w hen vehicle is not in
ope rati on in orde r to prev en t accidenta l eng ine sta rtin g or to
avoid unau thorized use by ch ild ren or others or thef t.
Post-Operation Care
Shut off the engine. Install rear of vehicle on a wide-base snowmo-
bile mech anical stand.
Remove snow and ice from rear suspension, track, front suspension,
steerin g mechanism and skis.
Always cover your snowmobile when leaving it overnight or during
extended per iods of inactivity. This will protect it from freezing as
well as retain its appearance.
140
_________________________
To Next Page
Loading...
Need help?
General
