mmo2006-005-016_a
TYPICAL
1. Arrow pointing front of vehicle
CAUTION: Do not force or us e tools to pr y the bel t into plac e, as
thi s c ould cut or break the co rds in the bel t.
To install the drive b elt, first place belt between d rive pulley sheave s.
Then, between driven pulley sheaves, finishing with bottom.
Remove drive belt installer/remover. R einstall belt guard.
Close L H side panel.
Drive B elt Height Adjustment
To ob tain maxim um v ehic le performanc e and d riv e b elt long evi ty,
dr ive belt height adjustment must be performed every time a new
dr ive belt is installed.
N O TE: If correct adjustment is unattainable, contact an authorized
SKI-DOO dealer.
The drive b elt cord should be f lush with driven p ulle y edge . A djust
as required.
_________________________
203
To Next Page
Loading...
Need help?
General
