Pushandholdmodebuttonfor2secondstoresetthehourmeter.
M ultifunction Display code
If y our speedometer shows SCALE in the mu lti -fun ction disp lay, i t
means that the display selector button is stuck in the down position
or d epressed wh en the electrical system was activated.
Unit Selection (MPH vs km /h)
All Models
The speedometer is factory preset in m iles but it is possible to
change it to kilom eter reading, refer to the following procedure or
contact an authorized SKI-DOO dealer.
N O TE: Speedomet er, odom eter and trip meter will have t heir units
(kilometer or m iles) changed all together.
Stop engine and open LH side panel.
Connectors are located underneath console near steering column.
Underneath console, look for:
– 1 circuit male connector housing with BLACK/GREY wire
– 1 circuit female connector housing with BLA CK/B LUE w ire.
Cut locking ties. Plug connectors together to change units from
miles to kilometers.
Unplu g to return to m il es readi ng. Fas ten c onnector to h arness w ith
locking ties.
74
_________________________
To Next Page
Loading...
Need help?
General
