SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2016 136
4. To force the gateway to attempt to sync with the ACS, click the GetRPCMethods button. This will assist you in verifying the
TR-069 parameters entered above.
5. Click Apply/Save to commit your changes.
STUN Config
STUN stands for “Simple Traversal of UDP through NATs”. STUN enables a device to find out its public IP address and the type of NAT
service it is sitting behind.
STUN is most commonly used with older modems under ACS management connected via a NAT gateway. NAT accommodates a LAN-
side device that has been allocated a Private IP address such as a CPE device on a private network behind an ONT. In this instance,
the regular CWMP Connection Request mechanism to talk to the modem gateway cannot be used to initiate a session with that ACS.
A STUN server receives STUN requests and sends STUN responses. STUN servers are generally attached to the public Internet.
On this page, when a STUN server is present within the infrastructure of the Service Provider, you can configure this gateway with
the connectivity specifics for that server.
1. In the left navigation bar, click Management > Management Server > STUN Config. The STUN Configuration page appears.
2. To view the required STUN settings, click STUN Server Support.
3. Complete the fields in accordance with the implementation specifics of your server. Information about the fields is provided
in the table below.
4. Click Save/Apply to commit your changes.
The fields on this page are explained in the following table.
To Next Page
Loading...
Need help?
General