SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2016 67
Adding a MAC Filtering Rule
You cannot edit rules but you can add new ones and then remove the obsolete ones.
1. On the MAC Filtering page, click Add. The following page appears.
2. Fill in the fields, using the information provided in the following table.
3. Click Save/Apply to commit your changes.
The fields on this page are explained in the following table.
Field Name Description
Protocol Type Select the protocol associated with the device at the destination MAC address. Options are
PPPoE
,
IPv4
,
IPv6
,
AppleTalk
,
IPX
,
NetBEUI
, and
IGMP
.
Destination MAC
Address
Enter the MAC address of the hardware you wish to associate with this filter.
Source MAC
Address
Enter the MAC address of the device that is originating requests intended for the device asso-
ciated with the
Destination MAC Address
.
Frame Direction Select the incoming/outgoing packet interface. Options are
LAN<=>WAN
,
WAN=>LAN
, and
LAN-
N=>WAN
. The default is
LAN<=>WAN
.
WAN Interfaces Select the interface to which the filter should be applied.
Parental Control
In this section, you can configure the Parental Control features of your SmartRG gateway to restrict Internet access to certain hours
and to certain URLS.
To Next Page
Loading...
Need help?
General