SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2016 83
1. In the left navigation bar, click Advanced Setup > Routing > RIP, and then click Add. The following page appears.
2. Fill in the fields, using the information in the table below.
3. Click Apply/Save to commit your changes.
The fields on this page are explained in the following table.
Field Name Description
Interface Displays a list of available WAN interfaces. Complete the line item(s) associated with the inter-
face where you wish to employ RIP.
Version Select the version of Routing Interface Protocol you desire. Reference RFC 1058 and RFC 1453 for
detailed information on RIP versions. Options are: 1, 2, and Both.
Operation Select the operation mode. Options are:
l Active: This mode listens and advertises routes.
l Passive: This mode listens only. It does not advertise routes.
Enabled Select to employ RIP on the displayed interface.
DNS
In this section, you can configure a DNS server, dynamic DNS and static DNS.
To Next Page
Loading...
Need help?
General