SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2016 25
Advanced Setup
In this section, you can configure network interfaces, security, quality of service settings, and many other settings for your gateway
and network.
Layer2 Interface
In this section, you can configure interfaces for ATM and PTM interfaces. Generally you can accept the settings configured by
default. If your network is highly customized, you may need to modify some of the settings, such as Username and Password.
ATM Interface
On this page, you can configure Asynchronous Transfer Mode / Permanent Virtual Conduit (ATM/PVC) settings for your gateway. You
can customize latency options, link type, encapsulation mode, and more.
Note: Devices (routers) on both ends of the connection must support ATM / PVC.
1. In the left navigation bar, click Advanced Setup > Layer2 Interface > ATM Interface and then click Add. The following page
appears.
To Next Page
Loading...
Need help?
General