SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2016 80
Routing
In this section, you can configure default gateways, static routing, policy routing and RIP settings.
Default Gateway
On this page, you can configure the default gateway interface list to establish access priority, that is, interfaces are accessed in the
order listed in the Selected Default Gateway Interfaces column.
Note: You must configure the IPv6 interface before attempting to assign it as the default gateway interface.
1. In the left navigation bar, select Advanced Setup > Routing. The following page appears.
2. Select the interfaces that you want used as default gateway interfaces. Click the arrows to move your selection between
the columns. Move the highest priority interface first, followed by the next highest priority interface, and so on.
3. (Optional) In the Selected WAN Interface field, select an IPv6 interface. The default is NO CONFIGURED INTERFACE.
4. Click Apply/Save to commit your changes.
Static Route
On this page, you can configure static routes for your network. A static route is a manually configured, fixed route for IP data. You
can enter a maximum of 32 entries.
To Next Page
Loading...
Need help?
General