SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2016 96
On this page, you can enable and remove IPSec connections, or edit existing connections.
1. In the left navigation bar, click Advanced Setup > IP Sec and then click Add New Connection. The following page appears.
2. Complete the fields, using the information provided in the following table.
3. If desired, click Advanced IKE Settings to select Phase 1 and Phase 2 specific parameters. For detailed information about
these settings, see "Advanced IKE Settings".
4. Click Apply/Save to commit your changes.
The fields on this page are explained in the following table.
To Next Page
Loading...
Need help?
General