Chapter 2 Installing the display
smarttech.com/kb/171744 25
Important
Do not use the RJ45 jack on an OPSPC to connect to a network.
Note
The network display’s connection is shared internally with an OPSPC.
Tip
If you’re using one of the display’s RJ45
jacks to connect to an Ethernet network,
you can connect the other jack to a
computer to provide network access for the
computer. This is particularly useful if there
is only one wired network connection in the
room. (Network access is available when
the display is on or in Standby mode but
not when it’s in Power Save mode).
To Next Page
Loading...
