SMART Board GX User Manual

Chapter 2 Installing the display
smarttech.com/kb/171744 26
Connecting power and turning on the display for
the first time
To connect the display to power
Connect the supplied power cable from the AC power inlet on the back of the display to a power
outlet.
Note
Refer to the display’s specifications for power requirements and power consumption information
(see More information on page15).
To turn on and set up the display for the first time
Important
Install the OPS PC module before you turn on the display.

SMART Board GX Specifications

General

Aspect Ratio	16:9
Touch Points	20
Response Time	8 ms
Brightness	350 cd/m²
Display Size	75 inches
Resolution	4K UHD (3840 x 2160)
Connectivity	HDMI, USB, VGA
Display Type	LED
Viewing Angle	178°
Included Software	SMART Notebook