Chapter 4 Maintaining the display
smarttech.com/kb/171744 55
2. Flick the power switch (beside the AC power inlet) on the bottom of the display’s rear surface to the
OFF (O) position.
SBID-GX165 SBID-GX175
and
SBID-GX186
To turn the display on
1. Flick the power switch (beside the AC power inlet) on the bottom of the display’s rear surface to the
ON (I) position.
2.
Press the Power button on the front control panel or the remote control for five seconds.
To turn the display on or off (with an OPS module installed)
l
If OPS is currently set as the
Boot input Source
input (see
Source settings
on page85), the OPS
module will start automatically when the display is turned on.
l
Before turning off the display, turn off the OPS module using the power controls on the OPS module
(such as the
Shut down
command in the Windows 10 start menu on the OPS).
l
When the OPS module is turned off, it is then safe to turn off the display using the steps listed above
in
To turn the display off
.
To Next Page
Loading...
Need help?
General
