SMC Networks HRS012-A*-10-* - Page 109

HRX-OM-M090
Chapter 5 Display and setting of various functions
HRS Series 5.18 Communication function
5-57
Slave addresses（MODBUS） Setting and checking
9. Press the [SEL] key once.
The set screen of slave addresses (MODBUS) is displayed on the digital display.
PV
SV
10. Select slave addresses (MODBUS) from the table below with [▲] key or [▼] key, and
confirm by pressing “SEL”.
Table 5.18-6 List of set value
Set value Explanation
Initial value
(Default setting)
Setting/checking are not available unless the
serial protocol setting is MODBUS.
to
Sets of slave addresses for MODBUS.
Set range is 1 to 99.
Communication speed （MODBUS） Setting and checking
11. Press the [SEL] key once.
The set screen of communication speed (MODBUS) is displayed on the digital display.
PV
SV
12. Select communication speed (MODBUS) from the table below with [▲] key or [▼] key,
and confirm by pressing “SEL”.
Table 5.18-7 List of set value
Set value Explanation
Initial value
(Default setting)
Setting/checking are not available unless the
serial protocol setting is MODBUS.
9600bps
19200bps
○
Slave addresses（simple communication protocol） Setting and checking
13. Press the [SEL] key once.
The set screen of slave addresses (simple communication protocol) is displayed on the
digital display.
PV
SV