HRX-OM-M090
Chapter 5 Display and setting of various functions
5.18 Communication function HRS Series
5-62
30. Select contact input signal 1 from the table below with [▲] key or [▼] key, and confirm
by pressing “SEL”.
Table 5.18-16 List of set value
Set value Explanation
Initial value
(Default setting)
No input signal
Start and stop signal input
○
External switch signal input(N.O. type)
∗
4,
∗
5
External switch signal input (N.C. type)
∗
4,
∗
5
∗4：When the setting of the communication mode is “DIO mode”, “External switch signal” cannot
be set.
∗5：When the setting of the communication mode is “SEIRAL mode” and the protocol setting is
“Simplified communication protocol 2”, “External switch signal” cannot be set.
Contact input signal 1 type Setting and checking
31. Press the [SEL] key once.
The set screen of contact input signal 1 type is displayed on the digital display.
PV
SV
32. Select contact input signal 1 type from the table below with [▲] key or [▼] key, and
confirm by pressing “SEL”.
Table 5.18-17 List of set value
Set value Explanation
Initial value
(Default setting)
Setting/checking are not available if the
setting of contact input signal 1 is OFF.
Alternate signal
○
Momentary signal
∗
6
∗6：Used when the setting of the contact input 1 is “Operation stop signal input”.
Contact input signal 1 delay timer of reading Setting and checking
33. Press the [SEL] key once.
The set screen of the contact input signal 1 delay timer of reading is displayed on the
digital display.
PV
SV
To Next Page
Loading...
