Command Line Interface
4-20
4
Default Setting
Level 15
Command Mode
Normal Exec
Command Usage
• “super” is the default password required to change the command mode from
Normal Exec to Privileged Exec. (To set this password, see the enable
password command on page 4-26.)
• The “#” character is appended to the end of the prompt to indicate that the
system is in privileged access mode.
Example
Related Commands
disable (4-20)
enable password (4-26)
disable
This command returns to Normal Exec mode from privileged mode. In normal
access mode, you can only display basic information on the switch's configuration or
Ethernet statistics. To gain access to all commands, you must use the privileged
mode. See “Understanding Command Modes” on page 4-5.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
The “>” character is appended to the end of the prompt to indicate that the
system is in normal access mode.
Example
Related Commands
enable (4-19)
Console>enable
Password: [privileged level password]
Console#
Console#disable
Console>
To Next Page
Loading...
Need help?
General
