To Next Page

To Previous Page

2-1

Chapter 2: Initial Configuration

Connecting to the Switch

Configuration Options

The switch includes a built-in network management agent. The agent offers a variety

of management options, including SNMP, RMON (Groups 1, 2, 3, 9) and a

web-based interface. A PC may also be connected directly to the switch for

configuration and monitoring via a command line interface (CLI).

Note: The IP address for this switch is obtained via DHCP by default. To change this

address, see “Setting an IP Address” on page 2-4.

The switch’s HTTP web agent allows you to configure switch parameters, monitor

port connections, and display statistics using a standard web browser such as

Netscape version 6.2 and higher or Microsoft IE version 5.0 and higher. The switch’s

web management interface can be accessed from any computer attached to the

network.

The CLI program can be accessed by a direct connection to the RS-232 serial

console port on the switch, or remotely by a Telnet connection over the network.

The switch’s management agent also supports SNMP (Simple Network

Management Protocol). This SNMP agent permits the switch to be managed from

any system in the network using network management software such as

HP OpenView.

The switch’s web interface, CLI configuration program, and SNMP agent allow you

to perform the following management functions:

• Set user names and passwords

• Set an IP interface for a management VLAN

• Configure SNMP parameters

• Enable/disable any port

• Set the speed/duplex mode for any port

• Configure the bandwidth of any port by limiting input rates

• Control port access through IEEE 802.1X security or static address filtering

• Filter packets using Access Control Lists (ACLs)

• Configure up to 256 IEEE 802.1Q VLANs

• Enable GVRP automatic VLAN registration

• Configure IGMP multicast filtering

• Upload and download system firmware via TFTP

• Upload and download switch configuration files via TFTP

• Configure Spanning Tree parameters

• Configure Class of Service (CoS) priority queuing

SMC Networks SMC8126L2 User Manual

Other manuals for SMC Networks SMC8126L2