SMC Networks SMC8126L2 User Manual

Flash/File Commands
4-69
4
whichboot
This command displays which files were booted when the system powered up.
Syntax
whichboot [unit]
unit - Stack unit. (Always unit 1)
Default Setting
None
Command Mode
Privileged Exec
Example
This example shows the information displayed by the whichboot command. See
the table under the dir command for a description of the file information displayed by
this command.
boot system
This command specifies the image used to start up the system.
Syntax
boot system [unit:] {boot-rom| config | opcode}: filename
The type of file or image to set as a default includes:
• boot-rom* - Boot ROM.
• config* - Configuration file.
• opcode* - Run-time operation code.
• filename - Name of the configuration file or code image.
• unit* - Specifies the unit number. (Always unit 1)
* The colon (:) is required.
Default Setting
None
Command Mode
Global Configuration
Console#whichboot
file name file type startup size
(byte)
------------------------------------ ------------------ -----------
Unit1:
D2218 Boot-Rom image Y
214124
V2271 Operation Code Y
1761944
Factory_Default_Config.cfg Config File Y
5197
Console#

SMC Networks SMC8126L2 Specifications

General

Brand	SMC Networks
Model	SMC8126L2
Category	Switch
Language	English