Example
4-201
4
Command Mode
Privileged Exec
Example
Multicast Filtering Commands
This switch uses IGMP (Internet Group Management Protocol) to query for any
attached hosts that want to receive a specific multicast service. It identifies the ports
containing hosts requesting a service and sends data out to those ports only. It then
propagates the service request up to any neighboring multicast switch/router to
ensure that it will continue to receive the multicast service.
IGMP Snooping Commands
Console#show policy-map interface ethernet 1/5
Service-policy rd_policy input
Console#
Table 4-67 Multicast Filtering Commands
Command Groups Function Page
IGMP Snooping Configures multicast groups via IGMP snooping or static assignment,
sets the IGMP version, displays current snooping and query settings,
and displays the multicast service and group members
4-201
IGMP Query Configures IGMP query parameters for multicast filtering at Layer 2 4-206
Static Multicast Routing Configures static multicast router ports 4-209
IGMP Filtering and
Throttling
Configures IGMP filtering and throttling 4-211
Multicast VLAN Registration Configures a single network-wide multicast VLAN shared by hosts
residing in other standard or private VLAN groups, preserving
security and data isolation for normal traffic
4-212
Table 4-68 IGMP Snooping Commands
Command Function Mode Page
ip igmp snooping Enables IGMP snooping GC 4-202
ip igmp snooping vlan static Adds an interface as a member of a multicast group GC 4-202
ip igmp snooping version Configures the IGMP version for snooping GC 4-203
ip igmp snooping
leave-proxy
Enables IGMP leave proxy on the switch GC 4-203
ip igmp snooping
immediate-leave
Enables IGMP immediate leave for a VLAN interface IC 4-204
show ip igmp snooping Shows the IGMP snooping and query configuration PE 4-203
show mac-address-table
multicast
Shows the IGMP snooping MAC multicast list PE 4-205
To Next Page
Loading...
Need help?
General
