SMC Networks SMC8126L2 - Figure 3-87 Queue Mode; Show Queue Bandwidth; Show Queue Mode

Command Line Interface
4-188
4
Command Usage
• CoS values assigned at the ingress port are also used at the egress port.
Example
The following example shows how to change the CoS assignments:
Related Commands
show queue cos-map (4-189)
show queue mode
This command shows the current queue mode.
Default Setting
None
Command Mode
Privileged Exec
Example
show queue bandwidth
This command displays the weighted round-robin (WRR) bandwidth allocation for
the four priority queues.
Default Setting
None
Command Mode
Privileged Exec
Console(config)#interface ethernet 1/1
Console(config-if)#queue cos-map 0 0
Console(config-if)#queue cos-map 1 1
Console(config-if)#queue cos-map 2 2
Console(config-if)#exit
Console#show queue cos-map ethernet 1/1
Information of Eth 1/1
Traffic Class : 0 1 2 3 4 5 6 7
Priority Queue: 0 1 2 1 2 2 3 3
Console#
Console#show queue mode
Queue mode: wrr
Console#