SMC Networks SMC8126L2 User Manual

Command Line Interface
4-68
4
dir
This command displays a list of files in flash memory.
Syntax
dir [unit:] {{boot-rom: | config: | opcode:} [:filename]}
The type of file or image to display includes:
• boot-rom
- Boot ROM (or diagnostic) image file.
• config - Switch configuration file.
• opcode - Run-time operation code image file.
• filename - Name of the configuration file or code image.
• unit - Stack unit. (Always unit 1)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• If you enter the command dir without any parameters, the system displays all
files.
• A colon (:) is required after the specified unit number.
• File information is shown below:
Example
The following example shows how to display all file information:
Table 4-26 File Directory Information
Column Heading Description
file name The name of the file.
file type File types: Boot-Rom, Operation Code, and Config file.
startup Shows if this file is used when the system is started.
size The length of the file in bytes.
Console#dir 1:
file name file type startup size
(byte)
---------------------- -------------- ------- -------------
D2218 Boot-Rom image Y
214124
V2271 Operation Code Y
1761944
Factory_Default_Config.cfg Config File Y
5197
--------------------------------------------------------------
Total free space:
5242880
Console#

SMC Networks SMC8126L2 Specifications

General

Brand	SMC Networks
Model	SMC8126L2
Category	Switch
Language	English