SMC Networks SMC8126L2 - Switchport Dot1 Q-Tunnel Mode

VLAN Commands
4-177
4
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
QinQ tunnel mode must be enabled on the switch for QinQ interface settings
to be functional.
Example
Related Commands
show dot1q-tunnel (4-178)
show interfaces switchport (4-125)
switchport dot1q-tunnel mode
This command configures an interface as a QinQ tunnel port. Use the no form to
disable QinQ on the interface.
Syntax
switchport dot1q-tunnel mode <access | uplink>
no switchport dot1q-tunnel mode
• access – Sets the port as an 802.1Q tunnel access port.
• uplink – Sets the port as an 802.1Q tunnel uplink port.
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
Use the dot1q-tunnel system-tunnel-control command to set the switch to
QinQ mode before entering this command.
Example
Related Commands
show dot1q-tunnel (4-178)
show interfaces switchport (4-125)
Console(config)#dot1q-tunnel system-tunnel-control
Console(config)#
Console(config)#interface ethernet 1/1
Console(config-if)#switchport dot1q-tunnel mode access
Console(config-if)#