Quality of Service Commands
4-199
4
service-policy
This command applies a policy map defined by the policy-map command to the
ingress queue of a particular interface. Use the no form to remove the policy map
from this interface.
Syntax
[
no
]
service-policy
input
policy-map-name
•
input
- Apply to the input traffic.
•
policy-map-name
- Name of the policy map for this interface.
(Range: 1-16 characters)
Default Setting
No policy map is attached to an interface.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• You can only assign one policy map to an interface.
• You must first define a class map, then define a policy map, and finally use
the service-policy command to bind the policy map to the required interface.
Example
This example applies a service policy to an ingress interface.
show class-map
This command displays the QoS class maps which define matching criteria used for
classifying traffic.
Syntax
show class-map
[class-map-name]
class-map-name - Name of the class map. (Range: 1-16 characters)
Default Setting
Displays all class maps.
Command Mode
Privileged Exec
Console(config)#interface ethernet 1/1
Console(config-if)#service-policy input rd_policy
Console(config-if)#
To Next Page
Loading...
Need help?
General
