Introduction
1-6
1
System Defaults
The switch’s system defaults are provided in the configuration file
“Factory_Default_Config.cfg.” To reset the switch defaults, this file should be set as
the startup configuration file (page 3-19).
The following table lists some of the basic system defaults.
Table 1-2 System Defaults
Function Parameter Default
Console Port
Connection
Baud Rate 9600
Data bits 8
Stop bits 1
Parity none
Local Console Timeout 0 (disabled)
Authentication Privileged Exec Level Username “admin”, Password “admin”
Normal Exec Level Username “guest”, Password “guest”
Enable Privileged Exec from Normal
Exec Level
Password “super”
RADIUS Authentication Disabled
TACACS Authentication Disabled
802.1X Port Authentication Disabled
HTTPS Enabled
SSH Disabled
Port Security Disabled
IP Filtering Disabled
Web Management HTTP Server Enabled
HTTP Port Number 80
HTTP Secure Server Enabled
HTTP Secure Port Number 443
SNMP SNMP Agent Enabled
Community Strings “public” (read only), “private” (read/write)
Traps Authentication traps: enabled
Link-up-down events: enabled
SNMP V3 View: default view
Group: public (read only) private (read/write)
To Next Page
Loading...
Need help?
General
