Multicast Filtering Commands
4-205
4
Example
The following shows the current IGMP snooping configuration:
show mac-address-table multicast
This command shows known multicast addresses.
Syntax
show mac-address-table multicast [vlan vlan-id] [user | igmp-snooping]
• vlan-id - VLAN ID (1 to 4094)
• user - Display only the user-configured multicast entries.
• igmp-snooping - Display only entries learned through IGMP snooping.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
Member types displayed include IGMP or USER, depending on selected
options.
Example
The following shows the multicast entries learned through IGMP snooping for
VLAN 1:
Console#show ip igmp snooping
Service status: Enabled
Querier status: Enabled
Leave proxy status: Disabled
Query count: 10
Query interval: 100 sec
Query max response time: 20 sec
Router port expire time: 300 sec
Immediate Leave Processing: Disabled on all VLAN
IGMP snooping version: Version 2
Console#
Console#show mac-address-table multicast vlan 1 igmp-snooping
VLAN M'cast IP addr. Member ports Type
---- --------------- ------------ -------
1 224.1.2.3 Eth1/11 IGMP
Console#
To Next Page
Loading...
Need help?
General
