SMC Networks SMC8126L2 User Manual

Command Line Interface
4-150
4
spanning-tree transmission-limit
This command configures the minimum interval between the transmission of
consecutive RSTP/MSTP BPDUs. Use the no form to restore the default.
Syntax
spanning-tree transmission-limit count
no spanning-tree transmission-limit
count - The transmission limit in seconds. (Range: 1-10)
Default Setting
3
Command Mode
Global Configuration
Command Usage
This command limits the maximum transmission rate for BPDUs.
Example
spanning-tree mst-configuration
This command changes to Multiple Spanning Tree (MST) configuration mode.
Default Setting
• No VLANs are mapped to any MST instance.
• The region name is set the switch’s MAC address.
Command Mode
Global Configuration
Example
Related Commands
mst vlan (4-151)
mst priority (4-151)
name (4-152)
revision (4-153)
max-hops (4-153)
Console(config)#spanning-tree transmission-limit 4
Console(config)#
Console(config)#spanning-tree mst-configuration
Console(config-mstp)#

SMC Networks SMC8126L2 Specifications

General

Switching Capacity	52 Gbps
Forwarding Rate	38.7 Mpps
MAC Address Table	8K
Form Factor	Rack-mountable
Layer	L2
Jumbo Frame Support	9KB
Features	VLAN, QoS, Port Mirroring, SNMP
Power Supply	Internal
Dimensions	440 x 44 mm

Summary

Chapter 1: Introduction

Key Features

Overview of the switch's core functionalities and capabilities.

Description of Software Features

Detailed explanation of the advanced performance-enhancing features of the switch.

Chapter 2: Initial Configuration

Connecting to the Switch

Steps and options for establishing initial management access to the switch.

Setting an IP Address

Procedures for manually configuring or dynamically obtaining an IP address for network management.

Basic Configuration

Essential initial configuration steps, including console connection and password setup.

Chapter 3: Configuring the Switch

Using the Web Interface

Guide to accessing and navigating the switch's web-based management interface.

Main Menu

Overview of the primary options available in the web interface's main menu.

Port Configuration

Detailed steps for configuring individual switch ports, including speed, duplex, and status.

Chapter 4: Command Line Interface

Using the Command Line Interface

Introduction to managing the switch using the Command Line Interface (CLI).

Console Connection

Steps for establishing a direct connection to the switch via the console port.

Entering Commands

Guidelines on constructing and entering commands in the CLI.

System Management Commands

Commands for managing system-level settings like logs, passwords, and user access.

User Access Commands

Configuration of user accounts, access levels, and passwords for management access.