SNMP Commands
4-111
4
Default Setting
• Default groups: public
17
(read only), private
18
(read/write)
• readview - Every object belonging to the Internet OID space (1.3.6.1).
• writeview - Nothing is defined.
• notifyview - Nothing is defined.
Command Mode
Global Configuration
Command Usage
• A group sets the access policy for the assigned users.
• When authentication is selected, the MD5 or SHA algorithm is used as
specified in the snmp-server user command.
• When privacy is selected, the DES 56-bit algorithm is used for data encryption.
• For additional information on the notification messages supported by this
switch, see “Supported Notification Messages” on page 5-13. Also, note that
the authentication, link-up and link-down messages are legacy traps and must
therefore be enabled in conjunction with the
snmp-server enable traps
command (page 4-106).
Example
17. No view is defined.
18. Maps to the defaultview.
Console(config)#snmp-server group r&d v3 auth write daily
Console(config)#
To Next Page
Loading...
