Contents
iii
Binding a Port to an Access Control List 3-73
Filtering IP Addresses for Management Access 3-74
Port Configuration 3-76
Displaying Connection Status 3-76
Configuring Interface Connections 3-78
Creating Trunk Groups 3-80
Statically Configuring a Trunk 3-81
Enabling LACP on Selected Ports 3-82
Configuring LACP Parameters 3-84
Displaying LACP Port Counters 3-86
Displaying LACP Settings and Status for the Local Side 3-88
Displaying LACP Settings and Status for the Remote Side 3-90
Setting Broadcast Storm Thresholds 3-91
Configuring Port Mirroring 3-93
Configuring Rate Limits 3-94
Rate Limit Configuration 3-94
Showing Port Statistics 3-95
Address Table Settings 3-99
Setting Static Addresses 3-99
Displaying the Address Table 3-100
Changing the Aging Time 3-102
Spanning Tree Algorithm Configuration 3-102
Displaying Global Settings 3-105
Configuring Global Settings 3-107
Displaying Interface Settings 3-111
Configuring Interface Settings 3-114
Configuring Multiple Spanning Trees 3-116
Displaying Interface Settings for MSTP 3-118
Configuring Interface Settings for MSTP 3-120
VLAN Configuration 3-122
IEEE 802.1Q VLANs 3-122
Enabling or Disabling GVRP (Global Setting) 3-125
Displaying Basic VLAN Information 3-126
Displaying Current VLANs 3-126
Creating VLANs 3-128
Adding Static Members to VLANs (VLAN Index) 3-129
Adding Static Members to VLANs (Port Index) 3-131
Configuring VLAN Behavior for Interfaces 3-132
Configuring IEEE 802.1Q Tunneling 3-133
Enabling QinQ Tunneling on the Switch 3-137
Adding an Interface to a QinQ Tunnel 3-138
Configuring Private VLANs 3-141
Enabling Private VLANs 3-141
Configuring Uplink and Downlink Ports 3-142
Protocol VLANs 3-142
To Next Page
Loading...
