10
Introduction Power Supply
2.5.3 IR Output
The IR output is for printing data.
For related information, see the following sections:
• “Setting Up to Print” on page 16
• “Printing” on page 51
2.5.4 Data Cable Connector
The connector on the data cable fits to adapters that connect the scan tool to a vehicle for testing.
For related information, see the following sections:
• “Cables” on page 11
• “Connecting to Vehicle Power” on page 14
2.6 Power Supply
This scan tool can receive power from three sources:
• Vehicle power
• Battery power
• AC/DC power supply
For related information, see “Supplying Power” on page 13.
2.6.1 Vehicle Power
This scan tool can receive 12V vehicle power via the data cable either by itself or in conjunction
with the auxiliary power cables included with this scan tool.
For related information, see the following sections:
• “Data Cable Connector” on page 10
• “Cables” on page 11
• “Connecting to Vehicle Power” on page 14
2.6.2 Battery Power
This scan tool can receive power from six internal AA batteries, which maintain the time, date, and
other custom settings but should not be the primary source of power. Vehicle power should be the
primary source of power during testing.
For related information, see the following sections:
To Next Page
Loading...
