User Manual |
34
3D Printing - 03 How to 3D Print
(2) Insert the lament. During heating, hang the lament onto the Filament Holder. Cut the bent end of the lament
using the diagonal pliers, and insert it into the 3D Printing Module.
Should the 3D Printing Module have filament inserted, heat the nozzle up to 200°C (392°F) and then
tap Unload to pull out the old filament before inserting a new one.
(3) Load the lament. After the nozzle reaches the target temperature, tap Load and gently thread the lament
until you feel the gear driving the lament in.
To Next Page
Loading...
