Snapmaker A350 - Level the Heated Bed; Printing Workflow

User Manual |
27
3D Printing - 03 How to 3D Print
03 How to 3D Print
3.1 3D Printing Workow
Pre-check
⇩
Level the Heated Bed
⇩
Load the Filament
⇩
Prepare the G-code File
⇩
Transfer the G-code File
⇩
Start Printing
⇩
Remove the Print
Before printing, you should thoroughly check the 3D printer and filament (see 5.2 Before You Print ).
3.2 Level the Heated Bed
Leveling Mode
There are four leveling modes to calibrate the Heated Bed—Auto Leveling, Manual Leveling, Heated Auto Leveling, and
Heated Manual Leveling. Normally, Auto Leveling or Manual Leveling is your go-to choice. If the first layer cannot stick
to the Heated Bed, try Heated Auto Leveling or Heated Manual Leveling to improve the first layer adhesion.
To switch the mode on the Touchscreen, tap Settings > 3D Printing > Auto Leveling or Heated Leveling.
Do not the touch the Heated Bed with bare hands while using the Heated Leveling mode.