User Manual |
41
3D Printing - 03 How to 3D Print
Start Printing on Luban via USB Cable
(1) In the 3D Printing G-code Generator, load the generated G-code le to Workspace by clicking Load G-code to
Workspace.
(2) Insert one end of the USB cable into the computer, and the other end into the Controller of the 3D printer.
(3) On Luban, click Workspace. In the Connection panel, click Serial Port > Refresh > Select the port of your 3D
printer in the drop-down list > Connect Luban to your 3D printer.
If you can’t find the port, unplug the USB cable and try again. For initial use, you need to download and
install the driver from snapmaker.com/product/snapmaker-2/downloads.
(4) After connection, Luban will prompt you to select your machine model and toolhead. Select and click Choose
to save the settings.
(5) Now you can start printing by clicking the Run button
.
Keep the cable connected until the printing job is completed. Otherwise, the job will be stopped.
To Next Page
Loading...
