30
GB
NET-VISION 7 - SOCOMEC
17. UPS MANAGEMENT
17.1. UPS CONTROL
If the remote controls are enabled by the UPS, NET VISION allows the following actions depend-
ing on UPS capabilities.
The access to the controls page is possible only for admin and read/write account users.
UPS Control
Transfer Load to Bypass
Enable eco mode
Enable standby mode
Alarm Acknowledgement
List of all controls managed by NET VISION
“Transfer Load to Inverter”
Controls are available if all conditions and permis-
sions are set by the UPS.
If a control is not present, it means that this control is
not allowed by the UPS.
“Transfer Load to Bypass”
“Enable eco mode”
“Disable eco mode”
“Enable standby mode”
“Disabled standby mode”
“Alarm Acknowledgement” Always present
For parallel UPS systems, the controls are sent to the system and dispatched to all the units
present.
NET VISION does not allow sending controls unit by unit.
To Next Page
Loading...
Need help?
General