SERVICE MANUAL
Sony Corporation
Published by Sony Techno Create Corporation
SPECIFICATIONS
HDD AUDIO PLAYER SYSTEM
9-893-833-01
2013J33-1
©
2013.10
US Model
Canadian Model
AEP Model
UK Model
Ver. 1.0 2013.10
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC DISTORTION (for the USA and Canada
only):
With 4 ohm loads, both channels driven, from 20 - 20,000Hz; rated 32 watts per channel
minimum RMS power, with no more than 10 % total harmonic distortion from 250 milliwatts to
rated output.
Amplifier section
POWER OUTPUT: 40 W + 40 W (4 ohms, 1 kHz, THD 10%)
Rated Power Output: 35 W + 35 W (4 ohms, 1 kHz, THD 0.9%)
Speaker impedance match: 4 ohms - 16 ohms
S/N ratio: 100 dB (20 kHz LPF, A Network)
Frequency response: 10 Hz - 100 kHz (+0 dB, –3 dB) (4 ohms, LINE IN)
Network section
Wired LAN
1000BASE-T/100BASE-TX/10BASE-T
Wireless LAN
Compatible standards: IEEE 802.11 b/g/n
Frequency band/channel: 2.4 GHz band, channels 1-11 (models for the USA and Canada),
channels 1-13 (models for Europe)
HDD section
Capacity
500 GB (*)
*
Some portions of the capacity are used for data management. Therefore, the capacity a user can
use is less than 500 GB.
Supported playback format
DSD (DSF, DSDIFF), LPCM (WAV, AIFF), FLAC, ALAC, ATRAC Advanced Lossless, ATRAC, MP3,
AAC, WMA (2 channels)
Jack section
Input section
COAXIAL IN
Input impedance: 75 ohms
Supported playback format: LPCM 2ch
Sampling frequency: 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz, 176.4 kHz, 192 kHz
Quantization bits: 16 bits, 24 bits
OPTICAL IN
Supported playback format: LPCM 2ch
Sampling frequency: 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz
Quantization bits: 16 bits, 24 bits
LINE IN 1, 2
Input sensitivity: 500 mV
Input impedance: 100 kilohms
Output section
Output jacks
LINE OUT
Output impedance: 2.2 kilohms
2 Hz - 80 kHz (–3 dB)
PHONES (headphone jack)
Stereo jack: 8 ohms or higher
EXT port
Type A USB, Hi-Speed USB, for connecting an external hard disk drive
General and others
Power requirements
Models for the USA and Canada: AC 120 V 60 Hz
Models for Europe: AC 230 V 50/60 Hz
Power consumption
Models for the USA and Canada
On: 80 W
During standby mode (when [Network Standby] is set to [Off]): 0.3 W
During standby mode (when [Network Standby] is set to [On] and a wired LAN is used): 2.6 W
During standby mode (when [Network Standby] is set to [On] and a wireless LAN is used): 2.8
W
Models for Europe
On: 85 W
During standby mode (when [Network Standby] is set to [Off]): 0.3 W
During standby mode (when [Network Standby] is set to [On] and a wired LAN is used): 2.6 W
During standby mode (when [Network Standby] is set to [On] and a wireless LAN is used): 2.8
W
Dimensions (approx.) (w/h/d)
265 mm × 88 mm × 304 mm (10 1/2 in. × 3 1/2 in. × 12 in.) including projecting parts and
controls
Mass (approx.)
5.8 kg (12 lbs 12 5/8 oz)
Supplied accessories
Design and specifications are subject to change without notice.
Remote control (1)
R03 (size-AAA) batteries (2)
AC power cord (mains lead) (1)
LAN cable (1)
HAP-S1
Note:
Be sure to keep your PC used for service and
checking of this unit always updated with the
latest version of your anti-virus software.
In case a virus affected unit was found during
service, contact your Service Headquarters.
To Next Page
Need help?
General
Weight and Dimensions
