Sony HAP-S1 - Page 36

HAP-S1
36
4-6-2. Select Input
It can select the external audio input terminal.
Procedure:
1. Enter the “6. Audio” mode.
(Refer to “4-6. Audio” on page 35)
2. Rotate the [PUSH ENTER] knob to select the “2. Select In-
put”.
3. Press the [PUSH ENTER] knob to enter the “2. Select Input”
mode.
(The volume control and muting function is available in this
mode)
6-2.Select Input
1. LINE1
2. LINE2
3. OPT
4. COAX
5. Back to Audio Menu
4. Select the external audio input terminal by rotating the [PUSH
ENTER] knob and press the [PUSH ENTER] knob.
5. The audio data that input from selected external audio input
terminal is output.
4-7. WiFi
Procedure:
1. Set the SSID and KEY of the connecting access point with
“SONY_HAP_TEST”.
2. Enter the service DIAG mode.
(Refer to “1. Entering Method of The Service DIAG Mode” on
page 31)
3. Rotate the [PUSH ENTER] knob to select the “7. WiFi”.
4. Press the [PUSH ENTER] knob to enter the “7. WiFi” mode.
7.WiFi
1. Network/Module Info
2. Ping/RSSI
3. Back to Main Menu
4-7-1. Network/Module Info
It can display the wireless network and module information.
Procedure:
1. Enter the “7. WiFi” mode.
(Refer to “4-7. WiFi”)
2. Rotate the [PUSH ENTER] knob to select the “1. Network/
module Info”.
3. Press the [PUSH ENTER] knob to enter the “1. Network/mod-
ule Info” mode.
Note: “1. IP Address”, “2. Subnet Mask” and “3. Default Gateway” sup-
ports only DHCP.
7-1.Network/Module Info
1. IP Address
2. Subnet Mask
3. Default Gateway
4. SSID
5. KEY
6. Module S/N
172.17.100.27
255.255.0.0
192.168.10.254
SONY_HAP_TEST
SONY_HAP_TEST
201305310100068
7-1.Network/Module Info
3. Default Gateway
4. SSID
5. KEY
6. Module S/N
7. HW ver.
8. Back to WiFi Menu
172.17.0.200
SONY_HAP_TEST
SONY_HAP_TEST
201305310100068
19
(Displayed characters/values in the above fi gure are example)
4-7-2. Ping/RSSI
It can display the results indicating whether or not the gateway
responded to the PING and RSSI value.
Note: This mode supports only DHCP.
Procedure:
1. Enter the “7. WiFi” mode.
(Refer to “4-7. WiFi”)
2. Rotate the [PUSH ENTER] knob to select the “2. Ping/RSSI”.
3. Press the [PUSH ENTER] knob to enter the “2. Ping/RSSI”
mode.
4. The results indicating whether or not the gateway responded
to the PING and RSSI value is displayed on the liquid crystal
display.
(When the gateway does not respond to the PING, “Error!!
Can’t get gateway-ip” is displayed on the liquid crystal dis-
play)
7-2.Ping/RSSI
Antenna 1
Ping to Gateway (192.168.10.254) OK
RSSI : -70
Antenna 2
Ping to Gateway (192.168.10.254) OK
RSSI : -59
Back to WiFi Menu
(Displayed characters/values in the above fi gure are example)