HCD-GT3D
Ver. Date Description of Revision
Delete four pieces of CUSHION (D-AMP) on SUB CHASSIS in page 15, 16, 75 and 76.
Delete four pieces of CUSHION (SMPS) on CHASSIS in page 17 and 76.
Delete four pieces of CUSHION, BUTTON on CDM section in page 13, 74 and 78.
Delete T CUSHION on PANEL, FRONT (SW) ASSY in page 14, 15, 75 and 77.
Delete HEMILON, 10XLX0.4 in page 13, 74 and 78.
Delete CLAMP, SLEEVE FERRITE for Argentina, Latin-American and Thai models in page 76 and 93.
How to search for a contact point of signal lines or the like in DIAGRAMS SECTION
If a contact point of a BLOCK DIAGRAM, PRINTED WIRING BOARD or SCHEMATIC DIAGRAM is shown in a different page, use
the PDF fi le search function to fi nd one.
e.g.) If a contact point is shown as
, follow the procedure below.
Procedure:
1. Press the [F] key while pressing the [Ctrl] key.
2. Input “>001Z” in the search box and press the [Enter] key.
3. The relevant part (page), where the contact point is shown, appears.
Note: If you still see the original page, press the [Enter] key again.
To Previous Page
Loading...
